DoorHan SWING-5000 Specifikace stáhnout pdf (Strana 7)

OPERATOR INSTALLATION

4.3. INWARD GATE OPENING

WARNING! Make sure, that the dimension C does not exceed the value indicated in the table below. Otherwise it is

necessary to improve the pole according to the indicated dimension value.

Pole

Hinge Gate leaf (closed)

Opening angle A, mm B, mm C

макс

, mm D, mm

90° 130 130 60 720

120° 130 110 50 720

Opening angle A, mm B, mm C

макс

, mm D, mm

90° 200 200 120 920

120° 200 140 70 920

Swing-5000

Swing-3000

Mounting plate

Front bracket

Building level

Rear bracket

Moving

end part

1) Fasten the rear bracket with the appropriate fastening plate to the pole, as shown in the picture above, observing

dimensions A and B, namely, the distance between the axis of the bracket’s central hole and of the gate hinge shank. The rear

bracket has several holes, which make installation of the operator easier and allow changing of the gate opening angle. Depending

on the position of the gate hinges you can lengthen or shorten the rear bracket.

WARNING! Increase of dimension B results in decrease of the gate opening angle and leaf angle speed, and in increase

of the operator’s linear force. Increase of the dimension B results in increase of the gate opening angle, leaf angle speed,

and the operator’s linear force.

2) Install steel end piece and lubricate all the parts with neutral grease.

3) When the gate is closed, install

the mounting plate on the gate leaf. Make

sure, that the front bracket is positioned

horizontally on the same level with the

rear bracket and that the dimension D

has been observed.

Mounting plate

Front bracket

Building level

Rear bracket

Moving

end part

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Komentáře k této Příručce

Žádné komentáře

DoorHan SWING-5000 Specifikace Strana 7

Komentáře k této Příručce

Související produkty a manuály pro Otvírač bran DoorHan SWING-5000