DoorHan SWING-5000 Specifikace stáhnout pdf (Strana 10)

RELEASE OPERATION

6. RELEASE OPERATION

1. Lift the cover.

2. Insert the key and turn it by 180°

3. Open or close the gate by hand.

4. To link the operator, turn the key by 180° again.

WARNING! Before releasing (linking) the operator, disconnect power supply.

Key

Cover

180°

7. MAINTENANCE

 The Swing-3000/5000 automatic system does not require any special servicing.

 Repairs may be carried out only by a qualified technician trained and certified at an authorized DoorHan centre.

 Be sure that after completion of installation the installer has shown the user how to release the door in case of emergency

and has given instructions on proper operation and maintenance of the automated system.

 When carrying out maintenance, it is recommended to use DoorHan original spare parts.

 Carry out maintenance of the automatic system at least every six months.

 Regularly check if the door is properly balanced and moves smoothly when automatically operated.

 Regularly check if the extreme positions of door travel are properly adjusted and safety devices are in good working

condition.

 In case of power failure you may need to restore operator’s settings. Once the power supply is restored, check the

automatic system for proper operation. If the operator settings have changed reprogram them following the instructions

given in the corresponding paragraph of this manual (pay special warning to Operation time programming).

 In case of power failure the door will stop. As soon as power supply is restored you can control the operator as usual.

 After expiration of life time, the item shall be delivered in a specialized disposal point!

 If you have lost this Manual, you may request for the duplicate copy to the following address: Kralovsky VRCH 2018,

Kadan, 43201, Czech Republic, or by e mail: [email protected].

 The producer (DoorHan) does not supervise the installation of operators, or carry out their maintenance, thus DoorHan

cannot be held liable for safety of installation, operation and maintenance of the equipment.

8. TROUBLESHOOTING

Symptom Possible reason Solution

Operator does not run

Power is off Make sure, that the power is on

Obstruction at gate’s movement Remove the obstruction

Bad wiring connection Check reliability of electric wiring connection

Operator is released Engage the operator

Operator stops suddenly Thermal protection is active Let the operator cool

The gate does not open or close completely

Wrong adjustment of limit switches Adjust the limit switches

Wrong operator programming Reprogram the operator

1 2 ... 5 6 7 8 9 10 11 12 13 14

Žádné komentáře

DoorHan SWING-5000 Specifikace Strana 10